keeps the vise attached to the threaded rod.
vise. The roll pin can be seen drilled through the tee fitting
and the threaded rod.
since I wasn't sure how the vise would operate. It seems to be
functioning fine.
measurements
|
|||||||||||||||||||||||||
| The coupling nut was epoxied into the end cap. |
|||||||||||||||||||||||||
|
|||||||||||||||||||||||||
| The coupling nut with the vise installed. |
|||||||||||||||||||||||||
|
|||||||||||||||||||||||||
| The cotter pin bearing against the recessed washer keeps the vise attached to the threaded rod. |
|||||||||||||||||||||||||
|
|||||||||||||||||||||||||
| The outside washer was recessed and screwed to the tail vise. The roll pin can be seen drilled through the tee fitting and the threaded rod. |
|||||||||||||||||||||||||
|
|||||||||||||||||||||||||
| The underside of the tail vise. I didn't glue any of the runners since I wasn't sure how the vise would operate. It seems to be functioning fine. |
|||||||||||||||||||||||||
|
|||||||||||||||||||||||||
| Click for rough sketches of the bench's measurements |
|||||||||||||||||||||||||
| Return to Page 1 |
|||||||||||||||||||||||||